Your well pump is responsible for siphoning water into a tank, where it’s then stored and pressurized. Whenever you turn on a faucet in your home, the water is sourced from this reserve. When the pump burns out, it’s no longer able to work at full capacity. Homeowners should follow the following preventative maintenance advice to prevent water pump burnout.

How to Avoid Water Pump Burnout

1. Install a Pressure Switch

A pressure switch is a popular way to control a water pump’s on and off cycle. To prevent your system from turning on when the well is dry or pressure is low, install a low-pressure cut-off switch. They feature a toggle-switch that will disconnect the appliance’s circuit and shut it off when the water pressure dips below a certain PSI. It’s a cheap and easy way to maintain your water pump, but keep in mind that you’ll need to manually pull the witch and hold it until pressure builds up in your the unit again.

2. Use a Pumpsaver

Your water pump will draw air when the tank levels are low. Pumpsavers–electronic sensors that detect amperage draws–will detect these low levels and shut down the pump circuit. It will then continue to re-test the circuit at pre-programmed time intervals until it can operate normally again. This is the priciest pump protection option, but also one of the most hands-off for homeowners.

For more advice on preventative maintenance for your well pump, speak with the professionals at Cox Construction and Plumbing. This Waynesboro, VA, plumber has more than 30 years of experience with services like drain cleaning, water heater repair, and new home construction. Learn more online or by calling (540) 943-8723 today.